HAMER STANDARD PICKGUARDS
THE KOREAN & INDONESIAN IMPORTED HAMER GUITARS HAVE MANY SMALL DIFFERENCES FROM THE ORIGINAL US-MANUFACTURED MODELS. IF YOU ARE WORKING ON AN IMPORTED HAMER, WE WILL NEED A TRACING OR THE ORIGINAL PICKGUARD TO MAKE AN ACCURATE REPRO.
PG 8008: Hamer USA "Standard"
8 screws & switch
IMPORTED HAMER STANDARD GUITARS LOOK THE SAME AS ABOVE BUT THE SCREW HOLES, OVERALL SHAPE, & PICKUP CUTOUTS VARY. WE HAVE ROUTING TEMPLATES FOR THE FOLLOWING ONES AND HAVE PROVIDED MEASUREMENTS TO HELP YOU FIND THE BEST FIT FOR YOUR GUITAR:
PG 8048: Hamer MIK "Standard"
Made in Korea, tongue between pickups has 2 screw holes and measures 3-1/16",
9 total perimeter screws, toggle switch hole, pickup edge is straight line,
tracing required
WE ALSO HAVE:
PG 80482: Hamer MIK "Standard"
Made in Korea, tongue between pickups has 1 screw hole (centered)
and measures 2-1/16", 8 total perimeter screws, toggle switch hole,
pickup edge is cut at a slight angle
at bridge, tracing required
WE ALSO HAVE:
PG 80484: Hamer "Standard" Import
Country of Origin not known, tongue between pickups has 1 screw hole (centered) and measures
2-5/16", 8 total perimeter screws, toggle switch hole, pickup edge is
cut at a slight angle at bridge, tracing required
WE ALSO HAVE:
PG 80486: Hamer 2010 "Standard" XT Series
Made in Indonesia, tongue between pickups has 1 screw hole (centered) and measures
2-5/16", 8 total perimeter screws, toggle switch hole, pickup edge is cut at a slight
angle at bridge, tracing required
WE ALSO HAVE:
PG 80488: Hamer 2010 MIK "Standard"
Made in Korea, tongue between pickups has 1 screw hole (centered) and
measures 2-5/16", 8 total perimeter screws, toggle switch hole, pickup edge
is cut at a slight angle at bridge,
tracing required